Holry Tr8 Lead Screw Direct Drive Stepper Motor Nema 17: External 42mmx62mm Bipolar 200 Steps/Rev 1.8 Degree 2 A/Phase

Product Description

The HOLRY' brand of hybrid Stepper Motor Linear Actuators come in five sizes, from 28 mm square to 86 mm square, corresponding to Nema size 11, size 14, size 17, size 23, and size 34. Each size has three to three form factors available - captive, non-captive and an external linear version.

There are over twenty different travels per step available, from. 0001563 inch (.00397 mm) to .003937 inch (1 mm). Microstepping can be used for even finer resolution.

The NEMA 17 Stepper Motor has an integrated 15 cm (5.9″) threaded rod as its output shaft, turning it into a linear actuator capable of precision open loop positioning.

Features / Benefits

Easy integration

Much easier to integrate into an application; can be coupled with programmable controllers/drivers.

More precision

Provide higher level of precision in motion control (speed, torque and force can be modified at different stages during movement).

Safer

Actuators are not susceptible to leakages or contamination - safer, cleaner and more convenient.

Lower cost

More economical in the long run, require less maintenance, are rugged and easy to operate / install, last longer and can be reliably used in different environmental conditions.

Other benefits

With simple quick connect wires and cable, actuators can be easily assembled, are more compact, and operate quietly.

Configurations

Kindly check our stepper motor catalog for full specifications.

Holry Stepper Motor Catalogue.pdf

The key differences between an external linear, non-captive, and captive motor is,

External	Non-captive	Captive
The external linear motor has the screw affixed to the rotor, so it rotates external to motor body, like a DC motor.	The non captive screw travels freely in and out of the motor body and does not rotate.	The captive has a short screw that is held mostly inside the motor body, coupled to a spline.
External linear motors are most akin to motorized rails where the nut is replaced by a driven carriage assembly. Non captive is generally the shortest overall length assembly, while the captive is the longest.

End Machine Options	Screw Nut Options
Please contact HOLRY for custom solutions.

Drawing of External NEMA 17 Lead Screw Stepper Motor

FAQ

• What is stepper motor and how it works?

  The stepper motor is an electromagnetic device that converts digital pulses into mechanical shaft rotation. Advantages of step motors are low cost, high reliability, high torque at low speeds and a simple, rugged construction that operates in almost any environment.

• What is difference between DC and stepper motor?

  Some DC motors also generate high torques at low speeds, but are more suited towards continuous uses, as their torque is constant over their speed range. The main difference is that, while stepper motors can push harder from rest, DC motors tend to have more sustained output.

• How are stepper motors controlled?

• Why is it called stepper motor?

  Stepper motors are so named because each pulse of electricity turns the motor one step. Stepper motors are controlled by a driver, which sends the pulses into the motor causing it to turn.

• What is step angle?

  Step angle is defined as the angle through which the stepper motor shaft rotates for each command pulse.

• What is stepper motor torque?

  If external force is applied to a stepping motor when it is stopped but energized, the attractive force generated between the rotor and stator works to maintain the stop position of the motor. This torque of withstanding the external force is called the holding torque.